Capacity in Mild steel
Drilling 3/8"
Tapping 1/2"
Spindle travel 2-1/2"
Air/line pressure required 50 to 100 lb.
Spindle thrust 4 times air line pressure
Minimum cycling pressure 5 lb.
Air consumption per spindle .01 cu. ft. per 2-1/2" stroke
Spindles taper 3/4" Combination drive
Spindle C/L to bed 7-1/2"
Clearance between drill chucks
Minimum 2"
Maximum 20"
Spindle speeds 1725 Motor - 575 to 5,000 RPM
Overall dimensions 27" x 66" x 54"
Approximate weight 1,565 lbs.
MOTOR SPECIFICATIONS
Two (2) 3/4 HP 3/60/230/460, 1725 RPM Spindle drive motors and contro
ls
Two (2) deep hole recipricators with accumulative speed controls
Two (2) Model 1A Tapmatic reversible tap holders, 0-1/4" capacity, 20
00 RPM
Coolant system
Hydraulic feed control
Cross slide table
NOTE MACHINE REPORTED TO HAVE VERY LOW HOURS AND ONLY RAN ONE A
PPLICATION
We use cookies to improve your experience. Privacy Policy.
We use different type of cookies to optimize your experience on our website. You may choose which type of cookies to allow and can change your preferences at any time. Remember that disabling cookies may affect your experience on the website. You can learn more about how we cookies by visiting our Privacy Policy.
These cookies are necessary to the core functionality our website and some of its features, such as access to secure areas.
These cookies are used to enhance the performance and functionality of our website but are nonessential. However, without these cookies, certain functionality may become unavailable.
These cookies gather information to help us understand site usage, measure marketing effectiveness, and personalize your experience.
These cookies enhance ad relevance, prevent repeat ads, ensure proper display, and sometimes tailor ads to your interests.
