YODER MODEL M2-1/2 HIGH FREQUENCY STAINLESS STEEL TUBE MILL

GENERAL SPECIFICATIONS:

Shaft diameter 2.5"
Minimum wall .040"
Maximum wall .100"
Minimum O.D. .750"
Maxiumum O.D. 3"
Hand of mill left to right
Tooling included
3/4" square, 1" square, 1-1/4" round, 1-5/8" round, 1-1/4" square,
1.9" round, 1-1/2" square, 1-3/4" square, 2" square, 2-1/2" square
Double uncoiler
Manufactured Littel
Model 40-80 Double Side 4000
Serial Number 780-74-70
Capacity 4,000 Lbs. per side
Miniumum I.D. 16"
Maximum I.D. 21"
Maximum O.D. 60"
Maximum strip width 24"
Strip entry guide 4 Roll
Forming section
4 breakdown, 2 finpass, 4 side roll stands
Weld Box
2 Roll
Bead Scarfing
1 manual station, auto lift
1 Saar Har metal roto scarf
2 Single head manual
Sizing
2 Ovaling guide stands on scarfing table
3 Horizontal roll sizing stands with cluster stand for pre-squaring
Turkshead
8 Roll for squares & rectangles
Cont'd on
Cutoff
Alpha model 30-135-20 with air clutch & brake, 25 HP AC, 1996
Accutronic accelerator & length control system Model C-95001D
Run-out Table
20' W/ manual collection carts for store & stack & tube
Electrical
100 HP DC Motor & Drive new in 1996, Warner-Seco drive
Weld system
High frequency induction welder by Thermatool Model CF1160,
150 KW/ W PLC control, threma-net computer, & heat exchanger
Dust collection
None
Roll lubrication system
Pump in base tanks, filter tech, deep bed filtration unit, heat
exchanger, sediment & sludge control