ABBEY ETNA MODEL 2KU STAINLESS STEEL TUBE MILL

GENERAL SPECIFICATIONS:

Shaft diameter 2"
Minumum wall .020"
Maximum wall .125"
Minimum O.D. .750"
Maximum O.D. 3.00"
Hand of mill Right to left
Tooling included
1", 1-1/4", 1-1/2", 1-5/8",1-3/4", 1.9", 2-1/2", 2-3/4"
Double uncoiler
Manufacuturer Littel
Model 60
Serial Number SR54375
Capacity 4,000 Lbs.
Minimum I.D. 16"
Maximum I.D. 21"
Maximum O.D. 60"
Maximum strip width 24"
Strip entry guide 4 Roll
Forming section
3 Breakdown top & bottom drive
4 Cluster side rolls
2 Finpass , 1 side roll
1 Seam guide
1 Two roll 8" dia. weld box height adj.
Bead flasher
Two-station Abbey-Etna flap wheel with Torit dust collector
Sizing
3 Horizontal stands, 3 Side rolls
Turkshead
4 Roll, Dual pane
Saw
18" Abrasive wheel cutoff saw
Cont'd on
Run-out table
20' Run out with driven pull out rolls
Electrical
2-20 HP DC Motors with 1996 Warner-Secco drive & 4 speed gear
box & gear reducers
Weld system
Single tig Hobart high frequency starter, Miller pulsing unit,
coolmate 4
Dust collection
Torit cyclone dust collector for flap wheels & saw
Roll lubrication system
Pump, tank, heat exchanger, filter