TUREK & HELLER MODEL WU20H10 STAINLESS STEEL TUBE MILL

GENERAL SPECIFICATIONS:

Capacity 1/2" to 2-1/2"
Hand of mill Left to Right
Composed of the following pieces of equipment
Double uncoiler
Manufacturer Littel
Model 60-24
Serial Number 8439579
Capacity 6,000# Per Side
Minimum I.D. 16"
Maximum I.D. 20"
Maximum O.D. 72"
Maximum strip width 24"
Strip entry guide 4 Roll
Forming section
(a) 4 Breakdown rolls, horizontal shaft, 3 finpass horizontal shaft
(b) 5 Side roll stands in forming in finpass
Bead Flasher
Two -belt type, each belt 4" wide
Sizing
3 Horizontal shaft sizing stands and 3 side roll stands
Turkshead
8 Roll, used for making squares and rectangles
Saw
20" Turek & Heller abrasive saw cutout with automated speed tracking
to line speed
Run-out Table 20'
Cont'd on
Electrical
A) Mill drive is composed of three ten (10) HP DC motors controlled by a
reliance drive located
on main mezzanine. Each motor drives a 4 speed drive roll gearbox.
Weld system
A) Composed of a single tig powered by a Maxtron Model 450 made by Mille
r. Torch is cooled
by a cool mate four
B) 4 Roll weld box
C) Horizontal shafts 2.0"
Dust collection
A) A cyclone type dust collector located on the mezzanine directly behin
d mill #21, used for the
saw and the flashing heads
Roll lubrication system
A) Composed of a main pumping unit and settling tank , a distribution of
piping to all of the
roll stands, a head exchanger and a filter system are located behind the
mill.
There is a remote control panel for the saw locted behind the saw and the
tooling for this mill is
locted either on the mill or on the uppper mezzanine behind the uncoiler.