ENSHU MODEL DT-CL VERTICAL DRILLING & TAPPING CENTER

Travel amount
X-axis (transverse stroke, column) 19.7"
Y-axis (longitudinal stroke, saddle) 15.7 +8.3"(ATC)
Z-axis (vertical stroke, spindle head) 11.8 +3.1"(ATC)
Distance from table top to spindle 7.9" - 19.7"
Table
Table size for work area 27.6" x 15.7"
Maximum allowable weight of work 1,100 lbs.
Shape of table top surface 0.6" T-slots x 3
Spindle
Spindle speeds 120 - 10000 RPM
Spindle speed changes One step
Spindle nose taper 7/24 taper no. 30
Spindle bearing diameter 2"
Feed rate
Rapid feed rate 1417.3" x 1417 > 3"x
1417.3"/min.
Cutting feed rate 0.04" - 196.6"/min.
Jog feed rate 0 - 157.5"/min. (16
steps)
Automatic tool changer
Tool shank type MAS BT30
Pull stud type MAS P30T-1 (45 deg.)
Magazine tool capacity 12 tools
Maximum tool diameter 3.1"
Maximum tool length 7.9"
Maximum tool weight 6.6 lbs. (total weight
=
44 lbs.)
Tool selection method Absolute address short
access
Tool exchange time (tool-to-tool) 3.1 sec.
Tool exchange time (chip-to-chip) 4.5 sec.
Drive motors
Spindle drive motor High-speed coil (H)
AC7.5kw (30 min.
rating)/3.7kw
(continuous rating)
Low-speed coil (L)
AC5.5kw (20 min.
rating)/3.7kw (50 min.
rating)
Axis feed motor X,Y AC0.85kw,
ZAC1.3kw
Cutting fluid motor 0.18 kw
ATC arm motor 0.09 kw
Power consumption
Power supply 200/220 VAC +-10%,
50.60Hz +-2%, 19kVA
Air pressure supply 0.4 - 0.8MPa (4-
8kgf/cm) 1500 L/min
(atmospheric)
Tank capacity
Cutting fluid tank capacity 26.4 gal.
Overall dimensions (est.) 53.1"L x 108.7"W
x103"H
Weight incl. NC device (est.) 7,700 lbs.