INTER-SOURCE CONTINUOUS AUTOMATIC CHIP PROCESSING SYSTEM

GENERAL SPECIFICATIONS:

Screw conveyor
Batch processing is possible by allowing chips to accumulate in receivin
g
hopper while screw conveyor delivers a positive metered feed over a wide
range of material and chip configurations.
Parts separator with M2-4836 15Hp shredder
A high percentage of parts, bar ends and tooling are recovered from chip
s
before processing.
Chip wringer CA-6200E
30 inch continuous design provides maximum efficiency and reliability in
oil recovery, reducing oil cost, waste and environmental problems. The
result
is the dryest, cleanest chips possible.
Pneumatic discharge
Dry chips are conveyed from the wringer through the plant to holding con
tainers
remotely located from the system. Dry chip pneumatic conveying force is
created
by the chip wringer; no additional blowers or compressors are required.
Oil collection tank with chain sludge conveyor
Acts as primary filter by allowing recovered oil to accumulate while sed
iment
settles to tank bottom and is conveyored out.
Electric controls
Fully programmable controller provides sequential start ip, inter-lock s
afety
features and component status monitoring, cutter hammer PLC.

MOTOR SPECIFICATIONS

20 HP chip wringer main motor 230/460
Conveyor motors
Pump motors
NOTE New replacement price exceeds $120,000.00
*