10" X 48" CINCINNATI SERIES 430 ELECTRONIC COMMAND

Capacity
Nominal swing 10"
Maximum swing over table 10.9375"
Nominal lengths 18", 24" and 36"
Actual work length capacity 20", 30", 40"
Nominal feed angle relative to work axis 0, 30, 45 degrees
Maximum diameter ground with a new wheel 10"
Minimum diameter ground with minimum wheel 0
Wheelhead
Standard wheel guard 36" dia. x 4" wide
Wheel diameter (new) 36"
Wheel speed 670 RPM
Change sheaves reduced diameter wheels 830 RPM
Infeed on work diameter
Stock Removal -
-total feed increments of .001 0 - .999"
- medium feed increments of .001 0 - .099"
-fine feed increments of .0001 0 - .0099"
Stock removal rate - coarse .060 to .300 IPM
Stock removal rate - medium .028 to .150 IPM
Stock removal rate - fine .0015 to .030 IPM
Tarry - spark out .7 to 20 seconds
Gap eliminator rate (approximate) .350 on diameter
Rapid approach - slide movement 4"
(CONTINUED)
Table
Positioning travel +/- 4.5"
Travel per revolution of handwheel .200"
Travel per revolution of adjusting wrench 1"
Nominal work lengths 18", 24", 36"
Swivel (counter clockwise from above) 9, 8, 7 degrees
Swivel (clockwise from above) | 2, 2, 2 degrees
Taper per foot maximum on diameter, in inches 3.79,
3.38,
2.95
Head and footstock
Work centers #14 Jarno
Standard headstock speeds 34, 49, 70, 100, 144, 206
RPM
Center height from floor 43.5"
Spindle nose, live spindle Type A1 - size 6
Reservoir capacities
Coolant tank capacity 56 gallon
Slideway lube tank capacity 3.1 gallon
Hydraulic tank capacity 25 gallons

MOTOR SPECIFICATIONS

25 HP Grinding wheel motor
3 HP Hydraulic motor
1 1/2 HP Headstock motor
1/4 HP Lubrication motor
1/2 HP Coolant pump motor
Page 3 of 3