120" diameter 30,000 pound load capacity car table with winch type
car drive for a 17'0" car travel from the elevator centerlin and dual
rubber tire table drive. Total car height of 14" and a total work
swing of 10'0".
MOTOR SPECIFICATIONS
Two (2) type 25-RLM-195 Wheelabrator units each to be driven by
a 30 HP, 1800 RPM motor
Electrical Equipment 460 volts, 60 hertz, 3 phase current with 110
volt circuit controls
A.C. Motors All motors are totally enclosed, fan cooled, ball
bearing, squirrel cage, induction type.
A-C Controls Consists of motor control panel and separate
operator's control station both pre-wired in NEMA-12 enclosures.
This equipment is engineered by Wheelabrator Canada and
manufactured to our specifications by Canadian Controllers Limited
using Allen
Bradley componenets.
Wheelabrator Units Two (2) 30 HP, 1800 RPM design "B" motors
Lower Screw Conveyor Drive 5 HP, 1800 RPM design "B" motor
Elevator 7 1/2 HP, 1800 RPM design "B" motor
Door 3 HP, 1800 RPM, C-flange motor, design "D" with brake
Car 2 HP, 1800 RPM, C-flange motor
Table Two (2) 1 HP, 30 RPM, gearhead motors
Control Panel 8-motor control panel pre-wired to numbered
terminals
including all necessary magnetic starters, control relays, mainline
disconnect switch, circuit control transformer, current transformers.
Cabinet fabricated of 1/4" steel plate reinforced by structural steel
3/8" Thick supplemental Long-Lyfe blast chamber liners
1/2" Long-Lyfe liners in line with blast in cabinet
Work table top fabricated from abrasive resistant 11% to 14%
manganese steel
Power operated rubber roll-up door to provide a work opening
approximately 7'6" high minimum x 11'0" wide and a 6'0" minimum
work height clearance
Completely automatic abrasive reclamation and recycling system to
include
Gravity type hopper twin 12" diameter screw
conveyors below cabinet bar grating
12" x 34" belt and bucket type elevator with vent outlet pointing
towards centerline of machine
Upper screw and rotary screen
60" wide CFS abrasive separator
Totally enclosed "soundabrator" abrasive control valves
Superstructure with access platform, safety railings, toe boards
and safety cage ladder
Page 3 of3
Airblast touch-up facilities to include
Entrance door with electrical interlocks
Cabinet lights
One (1) small abrasive hopper
Operator's Control Station Operator's control station pre-wired to
numbered terminals including an elapsed time indicating wheel hour
meter, two (2) abrasive load indicating ammeters, blast cycle timer
and all necessary push buttons, selector switches and pilot lights
Accessories Lot of rotary limit switch for the door, solenoid
operated air valve for abrasive control and two (2) work car travel
limit switches
SEE ATTACHED SPECIFICATIONS
We use cookies to improve your experience. Privacy Policy.
We use different type of cookies to optimize your experience on our website. You may choose which type of cookies to allow and can change your preferences at any time. Remember that disabling cookies may affect your experience on the website. You can learn more about how we cookies by visiting our Privacy Policy.
These cookies are necessary to the core functionality our website and some of its features, such as access to secure areas.
These cookies are used to enhance the performance and functionality of our website but are nonessential. However, without these cookies, certain functionality may become unavailable.
These cookies gather information to help us understand site usage, measure marketing effectiveness, and personalize your experience.
These cookies enhance ad relevance, prevent repeat ads, ensure proper display, and sometimes tailor ads to your interests.
