CONTINUOUS CHIP PROCESSING SYSTEM

GENERAL SPECIFICATIONS:

Centrifuge ringer 35"
Screw conveyor with hopper (48" square) 18" x 1/2"
"Clump Breaker" at top of screw
Cart dumper 60" x 36" x 60"H
Drag conveyor for lines
Parts separator
Electrical panel
Screw conveyor
Batch processing is possible by allowing chips to accumulate in receiving
hopper while screw conveyor delivers a positive metered feed over a wide
range of material and chip configurations
Clump breaker
Breaks up clumps of chips prior to entering the wringer
Parts separator
A high percentage of parts, bar ends and tooling, are recovered from chip
s
before processing
Chip wringer
35 inch continuous design provides maximum efficiency and reliability in
oil recovery, reducing oil cost, waste and environmental problems. The
result is the driest, cleanest chips possible
Pneumatic discharge
Dry chips are conveyed from the wringer through the plant to holding
containers remotely located from the system. Dry chip pneumatic conveyin
g
force is created by the chip wringer; no additional blowers or compressor
s
are required
Oil collection tank with chain sludge conveyor
Acts as primary filter by allowing recovered oil to accumulate while
sediment settles to tank bottom is conveyed out
Electric controls
Fully programmable controller provides sequential start, inter-lock safet
y
features and component status monitoring. Allen Bradley controls with
1500 Micro Lodix PLC

MOTOR SPECIFICATIONS

30 HP Leeson chip wringer motor 3/60/220/440
Conveyor motors 3/60/220/440
Pump motors 3/60/220/440
This machine qualifies for a 1 year limited warranty at additional cost.