13" X 36" CINCINNATI HYDRASHIFT ENGINE LATHE

Capacity
Swing over bed 13-1/4"
Swing over cross slide 8-7/8"
Distance between centers (maximum turning length) 24
" to 60"
Headstock
Spindle speeds (12), standard 40 to 1 ratio 35 to 1200 RPM
Spindle speed range, high 53 to 1800 RPM
Spindle speed range, super high (extra cost) 88 to 300
0 RPM
Spindle reverse Electrical
Spindle nose, standard long taper key drive L-0
Spindle nose, camlock (super high speed range) D-1-4
Spindle, diameter of hole thru - L series only 1-1/2"
Spindle, size of center #3 Morse
Spindle bearing, front
Thrust load at 100 RPM 6727 lbs.
Radial load at 100 RPM 7861 lbs.
Spindle bearing, center
Thrust load at 100 RPM 4749 lbs.
Radial load at 100 RPM 5268 lbs.
Bed
Width 9-15/16"
Depth 9-3/16"
(CONT.)
Thread and Feed Range
Number of thread and feed changes 48
Range of threads per inch, low, standard and high speed range
s 3 to 184
Range of threads per inch, super high speed range 6 to 368
Range of feeds - carriage, low, standard and high speed range
s .0020 to .1224
IPR
Range of feeds - carriage, super high speed range .0010 to
.0612 IPR
Range of feeds - cross slide, low, standard and high speed ra
nges .0005 to
0.031
IPR
Range of feeds - cross slide, super high speed range .0
003 to .0155 IPR
Leadscrew (Acme) diameter in inches and threads per inch
1-1/8 to 8
Carriage and Compound Rest
Cross slide travel 9"
Top slide travel 2-3/8"
Tool holders - size of tool shank (number #1) 1/2" x 1-
1/8"
Carriage bearing on ways 18-1/4"
Width of bridge 6"
Tailstock
Spindle travel 4-1/2"
Spindle diameter 1-3/4"
Spindle - size of center #3 Morse
Tailstock setover, either side of center 1/2"
Taper Attachment
Maximum taper per foot 3-1/2"
Maximum turning length at one setting 12"
Maximum included angle 16 degrees
Approximate machine weight 3,000 lbs.
Page 3 of 3