ENGEL MODEL ES 150/80 VHRO ROTARY VERTICAL CLAMP HORIZONTAL

Engel vertical clamp ES 150/80 VHRO
830 CC90 Hardware with software
831 Process enhancement
832 Quality control package
835 Keyboard program
880 Level 2 software
881 Microflow pressure correct
882 Statistical data package
101 Leveling mounts
102 Closed waterflow on throat
110 Engel beige paint
416 240 volt Heater transformer
751 Ejector on moving platen
210 Air blow off w/timer & valve
374 150 Injection unit/35 mm
412 Ceramic heater bands
(CONT.)
866 Additional heat card 7 zone
4 Zone - 15 amp/heater box
Dual action CPM 10V shut-off nozzle
Bimex SUPERCARB 35 mm barrel
Nitralloy 135-M screw w/colmonoy #56 flights
CPM 10V Check ring
Heater distribution box for quick disconnect of barrel heaters
and thermocouples
839 Melt temperature probe
834 Multi-color graphics printer with cable
836 2 Cavity pressure QV-10 amplifiers with user selection of micrograph
1 at a time
2nd Barrel Assembly 25 mm w/Bimex SUPERCARB Barrel, Nitralloy 135-M
Screw
w/Colmonoy #56 Flights, CPM 10V Shut-off Nozzle, Ceramic Heate
r Bands and Melt
Temperature Probe (New never used)
Additional Machine requirements
1. Rotary table to rotate 180 deg. CW and back 180 deg. CCW.
2. Locate rolling control cabinet with printer on the front
left side of machine.
Cables to come out of the front of the electronics cab
inet.
3. Install an auto-purge program carriage retract, user se
lects number of strokes and
maximum time.
4. Add two lines of user defined text to the top of the micr
ograph page. User will
enter through the keyboard.
5. Auto start page to preheat barrel and mold heat for pre-p
rogrammed start times.
SPC Software
Graphics and report program
Automatic start up circuit
NOTE This machine was installed in a Research Laboratory of a Fortune 500
Company. The
original cost was $179,000.00. The machine has approximately 4900 hours of
operation and is
reported by the laboratory technicians to be in like new, excellent conditio
n.