38" TWO-ROLL HUNTER NON-FERROUS CONTINUOUS CASTING LINE

mixing nitrogen
and chlorine gases for degassing. (Power required 480 Volts, 10 Amps,
3 phase, 60
cycle).
Hunter Engineering Two Roll Caster
20" diameter x 40" wide horizontal rolls (upward vertical casting), cas
t 0.220" to .0285"
thick x 18" minimum to 38.25" maximum width aluminum sheet, alloys 1xxx
, 3xxx series
alloys, casting speed 10" to 60" per minute depending on alloy and thic
kness,
approximately 3,400 pounds per hour maximum. Caster complete with oper
ator's
console, 15 HP DC motor, Gear Drive, SCR AC/DC conversion, electrical c
ontrols and
wiring. Requires 200 to 280 gpm of cooling water (preferably recircula
ted treated cooling
tower water at 90 degree F maximum); compressed air at a minimum of 80
psig; and
power at 480 Volts, 125 Amps, 3 phase, 60 cycle.
One Central Hydraulic System furnishes hydraulic pressure for the Caster, th
e 5 Roll Bridle,
Re-Coiler and Coil Car, with 15 HP motor. (Power required 480 Volts, 3 pha
se, 60 cycles).
Pinch Roll and Loop Control
One pneumatically operated Pinch Roll Stand to feed the cast sheet into
the Shear, Bridle
and Coiler. The Loop Control System also functions from this unit to c
ontrol the Coiler
speed. Compressed air at 80 psig minimum required.
Edge Millers
One Double Edge Miller complete with a pneumatic chip collection/convey
ing system.
One 5 HP motor per Miller Head, and one 5 HP motor for Chip Collection
system (all
motors 480 Volts, 3 phase and 60 cycles).
GENERAL SPECIFICATIONS: (CONT)
Shear
One electrically operated sheet shear, 10 HP DC motor, SCR AC/DC conver
sion.
Bridle
One 5 Roll Tension Bridle, hydraulically operated top frame, non-powere
d rolls.
Coiler
One 20" ID x 72" OD Coiler, hydraulically expanded and contracted mandr
el, 15 HP DC
motor, SCR AC/DC conversion.
Coil Car
One 15,000 lb. capacity Coil Car, hydraulic lift and traverse.

Misc. Tooling
Misc. Spare Parts
Page 3 of 3
ADDITIONAL EQUIPMENT AVAILABLE AT EXTRA COST
One (1) Tip Oven
Electrically heated tip oven with a capacity for two (2) Sheet Caster T
ips. Complete with
its electrical switchgear and controls. (Unit requires 480 Volts, 20 A
mps, 3 phase, 60
cycle power).
PRICE P.O.R.
One completely equipped Caster Tips Fabrication Assembly Shop consisting of
Band Saw - Floor Model
Spare Saw Blades
Floor Model Electric Sander
4' x 4' Sheet of Ceramic Board
9" x 38.5" Ceramic Board
9" x 22" Ceramic Board
Rolls of Fiberfrax Paper
Fiberfrax Coating
Spare Dams for Tips
Complete Sets of Tip Spacer Plates
Spare End Plates for Tip Assembly
PRICE P.O.R.
New Caster Main Transmission Unit Box
PRICE P.O.R.
Bloom Heaters
PRICE P.O.R.