HEPBURN 1100 TON HYDRAULIC SCRAP METAL SHEAR SYSTEM

This system is designed to cut down oversized structural and plate steel fro
m 6' to 20' long into
useable melt shop lengths (approximately 4' long).
Approximate production rate 200 ton in 8 hours
Systems consists of
(1) Logerman Combination Hydraulic Squeeze Box and Hydraulic Pusher
Feed
Open size (approximately) 152" wide x 312" long
Closed size (approximately) 60" wide x 312" long
(2) Hepburn 1100 ton Hydraulic Scrap Metal Shear
Cutting force, maximum 1100 tons
Maximum knife return
Pull back capacity 550 tons
Clamp capacity, adjustable 22 to 250 tons
Shear opening width 63"
Shear opening height (at lowest point of upper blade when s
lide
is in up position), maximum 26"
Blade cutting angle 7 degrees
Cutting stroke (adjustable), maximum 35"
Maximum hydraulic system working pressure 2250 PSI
Pilot pressure 750 PSI

MOTOR SPECIFICATIONS

Two (2) 25 H.P. Air coolers
Five (5) 100 H.P. @ 1800 RPM Main drive motors each d
riving two (2)
hydraulic pumps
One (1) 7-1/2 HP @ 1800 RPM Main drive motor driving
filter circulating pump
Two (2) 3-1/2 HP @ 1800 RPM Main drive motors each dr
iving oil cooler fans
All motors are open drip proof, class B insulation fo
r operation on 575 volts,
3 phase, 60 Hz.
Speeds
Clamp advance, maximum 750 in./min.
Clamp retraction, maximum 750 in./min.
Knife exerting 245 ton cutting force 350 in./
min.
Knife exerting 550 ton cutting force 176 in./
min.
Knife exerting 1100 ton cutting force 88 in./m
in.
Knife retraction 350 in./min.

(CONT.)
(2) Hepburn 1100 ton Hydraulic Scrap Metal Shear (continued)
Clamp cylinder diameter Two (2) 12" cylinders
Shear cylinder diameter Two (2) 25" cylinders
Overall dimensions
Overall width (at base) 13'2"
Overall depth (at base) 7'0"
Overall height 22'6"
Static load on shear foundation 140 tons