L-TEC MODEL CM350-17 CNC PLASMA/OXYGEN CUTTING MACHINE

UCNC8 CNC Control mounted on machine
* Operating executive program stored in non-volatile permanent
EPROM memory
(24K Bytes spare for future enhancements)
* 300 feet (91.4 meters) of semi-conductor RAM memory for part
program storage
* Manual data input
* Absolute and incremental programming N3G2 X + 43 Y + 43 I43 J
43 M2
F3.1K.3PR
* Linear and circular interpolation - one block full circle
* Inch or metric programming resolution (0.001 inches of 0.1 mm
)
* 3 place kerf programming (.000 to .999 inches) or 0 to 25 mm
on tape or
manual
* Corner slowdown using pause command programming for machine c
ornering
* Automatic plasma height control hold on corners to prevent to
rch dipping
IBM PC with screen, keyboard, plotter & screen, and printer for offlin
e programming
and storage
Anderson dual bladder adjustable height water table 20' wide x 21' lon
g with controls
Two (2) Linde PHC-402 plasma power supplies
Two (2) Water cooling radiators for plasma systems
Four (4) Oxygen torch units
Six (6) Power stations (2 plasma, 4 oxygen)
Two (2) Pneumatic punch markers with plasma heads
Miscellaneous spare parts
Manuals
NOTE Past operator available to set-up at additional cost