72" X 0.142" X 66,000# IMPES CUT TO LENGTH LINE

GENERAL SPECIFICATIONS:

Width 12" min. 72" max.
Capacity 66,000 lbs
Gauge range .031" to .118"(60,000 p
si
yield)(.141" max. at
50,000 psi)
Coil I.D. 18.5" to 24"
Coil O.D. 36" to 82"
Sheet length 19.6" to 236"
Line speed 39 to 78 FPM (157 FPM
max.)
Line Direction right to left
Coil transfer car
Hyd lift and travel
Entry coil lift
Model E-9
25.5" lift
V coil saddle
Pit type
Double expanding mandrel type uncoiler
Model DC 4-200
18.5" to 20" I.D. w/24" bolt on pads
Hyd. wedge type expansion
Hyd. motorized feedup
Self contained hyd pwr unit
Air brake
Hydraulic slide base under both units
Entry stand
Model AR2 and AR44
Overarm hyd motorized holddown roll
Urethane covered roll
Hydraulic lift and extend peeler table
Double stub type edge trimmer
Entry edge guides, disc type
Manual adjustment
Entry passline rolls
10" Knife dia.,
3.5" dia. arbors
Non motorized
GENERAL SPECIFICATIONS: CONT
17 Roll precision leveller
Model SP 4A-200
Capacity .031" to .118" (60,000 psi yield) (.141" max. at 50,000 psi)
8 over 9 configuration
2.20" dia. x 78" face rolls
Last bottom roll removed
Motorized tilt front and back
Motorized tilt side to side
Back ups positioned with AC motor
8 Top backups
8 Bottom backups motorized
1 Spare back up assy
Speed range 39 - 78 FPM (157 FPM max.)
DC drive
Hump table
Conveyor roll top
Pinch rolls
Mechanical shear
Model C4L-190
74" x .138" at 60,000 psi yield (.177" max. at 50,000 psi)
120 SPM
7.5 HP AC motor
Air clutch & brake
Overdriven, down cut
Runout belt conveyor with positive stop
Manual adj. length measuring unit
19.6" to 236" long
Exit pinch rolls
Drop stacker
Conveyor rolls mounted at floor level
Side sheet retainers
End sheet stop
In storage
WAS $225,000.00